Your Paralenz Vaquita camera came with spare parts.
If the camera is showing the following signs, you might need to exchange the parts or remove them for cleaning:
- The activation switch is not as responsive as it used to be (turning the camera on, starting recording, etc.)
- The selector ring is not moving as smooth (might be salt build-up or sand)
- You have dived in very salty water - or you dive in such waters often
- You did not have a chance to clean your camera directly after your dive
If any of the above apply to your camera, you can view this instruction video. The screw size at the lens ring is a Torx T6.
If you have any questions or need more of the parts, please contact us directly here.
3
1
Was this article helpful?
2 out of 3 found this helpful
Hello, does this apply to the Dive+ camera as well?
Hi Lisa! No - the instructions for Paralenz Vaquita are not compatible with the previous models.
If you need to exchange the magnets in your Paralenz+ camera, please contact us here: https://support.paralenz.com/hc/en-us/requests/new