Maintenance of Paralenz+ Maintenance of Paralenz+

Maintenance of Paralenz+

Adrianna Adrianna

It is very important to make sure the camera is maintained in a proper way - to avoid malfunction of the hardware.

The camera has to be cleaned after each dive - especially in salt water

You should take a bucket of warm, fresh water (for the salt to dissolve fully), and work the selector ring and activation switch for a couple of minutes while submerged.

If you can sense some grains of sand inside the activation switch or selector ring - the parts can be removed - but please contact Customer Support first for instructions! 

If you are diving often (especially in high salinity waters), it is a good idea to remove the selector ring from time to time, clean the parts with magnets and apply silicone grease on both sides of the magnet.


Note: If you do not have a possibility to clean the camera right away, make sure to keep it wet - so the salt doesn't have a chance to crystallize.  


!It is very important not to use any chemicals/cleaning products with the camera, as it might damage the components!

Was this article helpful?

33 out of 45 found this helpful

Add comment

Article is closed for comments.