Pre-dive checklist Pre-dive checklist

Pre-dive checklist

Adrianna Adrianna

We recommend that before each dive the following is checked:

  1. Check that you have the newest firmware on your camera (if not, you can find instructions in this section)
  2. Make sure your o-rings are clean and shiny (not too much grease), and that there are no tears on them 
  3. Confirm that there are no cracks on the front lens glass and that the end cap and lens ring are tight
  4. Your battery should be fully charged before each dive for you to be able to record for 3+ hours in 1080p, 30fps 
  5. Check that you have enough space on your SanDisk SD card and clear it out when needed (we recommend formatting the SD card from time to time - Settings > Advanced > Format) 
  6. If you choose to mount your camera, make sure it is not sliding. For extra protection, you can always use additional straps 
  7. Double-check that you have the right settings on for the water you’ll be diving in 

Was this article helpful?

0 out of 1 found this helpful

Add comment

Article is closed for comments.